Gauge: Support Zones / Scale Ranges
Support zone configuration on gauges so that the user has an indication of whether the attribute is in a good or bad state.
If an attribute has limits defined for it in PI AF (LO, LOLO, HI, HIHI), the gauge should default to the limits by default.
AdminTodd Brown
(Product Manager, OSIsoft)
shared this idea
At this time, this item is not currently scheduled for a release of PI Vision. If this changes, this item will be updated to reflect the current status.
10 comments
-
Anonymous
commented
We would like the "Radial gauge" to be able to mark individual work areas defined in "Muliti-state". For example, the freness on the mp5 cover from 0 to 17 red range, from 17 to 21 yellow and from 21 to 30 green, and above red (the color on the scale and the current value would be marked with a digit). Below is how it is and how we would like it to be.
-
Frédéric Harvey-Lavergne
commented
I totally agree with that, AF and Vision should be linked on those parameters. Like Louis-Philippe said, it would be good to see where the zones are on the gauge, so you can see if you are close to Hi or Lo for example.
-
Hobbe
commented
This is a great idéa! Scale zones with the ability to have them custom colored. Powered by traits in AF or preffered attribute. Out of the box it should work with traits.
-
Matt Clark
commented
This would be something similar to a bullet graph where each range is illustrated all the time(normal/target, low, high, high high, etc). currently you can only see the multi-state range the data resides in at that time, this would allow uses to see the normal ranges all the time. Consider adding option to multi-state config to always shows the defined ranges
-
David Priest
commented
It would also be great to have this for the bar graph as well same feature set of being able to see the "set Points" and allow them to overlap as well.
-
Daniele Farris
commented
Besides the range of displayable values in the gauge, it would be nice to have markers for "target" and any other limits in the gauge. Same for the bars.
-
Vince Noyes
commented
Add radial dial multistate colors on dial ring, or on an inter-ring of the dial. This would show where needle is within the different states.
-
Zhenguan Tang
commented
As an end user of PI Vision, I would Vision to provide the capability to show up AF attribute traits ( HiHi, LoLo...) on all kinds of gaugues
-
Louis-Philippe Page-Morin
commented
But is there the ability to show the Zones on the gauge? I feel this would be useful.
-
Hobbe
commented
This should be basic functionality!