PI Connectors
Welcome to the
PI Connectors feedback page!
We created this forum to hear your ideas, feature suggestions and feedback on PI Connectors. Please suggest your most important features and design change ideas on this site, and vote for your favorite ideas.
Please note that your ideas and comments posted here are visible to all other users.
- For bugs, please open a case with OSIsoft Tech Support through myOSIsoft Customer Portal (https://my.osisoft.com) instead of sharing them on this site.
- For documentation feedback and bugs, please report to documentation@osisoft.com instead of sharing them on this site.
-
Synchronize behavior between PI Connector for Cygnet and Cygnet enumeration value representation
The values stored in the “Table Entry” column in Cygnet TRS should match the “State” column in the PI Server Digital states table. This way end users are not confused why the trends in PI do not match the trends in Cygnet.
9 votes -
Support VHS point History recovery for PI Connector for Cygnet
VHS points in Cygnet contain historical data. On startup, disconnection and at will, the connector should should attempt to recover history.
5 votes -
4 votes
-
Enhance the PI Connector for Cygnet Back Fill Utility to use select PI Points
Currently the back filling utility for the PI Connector for Cygent only permits back filling an entire data source. Sometimes it is desirable to back fill certain points, or a subset of a data source, that has missing data or gaps that need to be re-sent to the PI Data Archive.
4 votes -
Allow PI Connector for Cygnet to support a mix of VHS and CVS when Automatic UDC Recognition is enabled
With Automatic UDC recognition enabled, PI Connector for Cygnet defaults to placing all UDC's in the CVS column by default, or in the VHS column if "Prefer VHS for Automatic UDC recognition" is checked.
This behavior should be a preference, not an all-or-nothing selection - users would like Automatic UDC recognition to default to CVS or VHS, but also have the option to specify UDCs that do not follow the default behavior.
3 votes -
3 votes
-
Cygnet - Check for prerequisites during the installation process instead of in the logs on startup
Currently, if some Cygnet prerequisites are missing, the following error is logged:
Although the errors are clear, this verification step should also occur during the initial installation process.Please review the "Installation requirements for PI Connector for CygNet" in the User Guide.
And subsections "Install the ODBC drivers" and "Verify connectivity with ARS".3 votes -
1 vote
- Don't see your idea?