How can we improve PI Interfaces?

PItoPI should switch from COLD to WARM failover instead of exiting

As of version 3.8.1 COLD failover is no longer supported by the PI to PI Interface (https://techsupport.osisoft.com/Troubleshooting/Enhancements/19255OSI8). However, older versions supported COLD failover. In the case of upgrading the interfaces, the old configuration with COLD failover would cause them to refuse to start thus causing data loss or data delay.

The interface could instead log a warning that COLD failover is no longer supported and switch to WARM failover.

4 votes
Sign in Sign in with OSIsoft
Signed in as (Sign out)

We’ll send you updates on this idea

Alexandru Guzu shared this idea  ·   ·  Flag idea as inappropriate…  ·  Admin →

1 comment

Sign in Sign in with OSIsoft
Signed in as (Sign out)
Submitting...
  • Colan Dray commented  ·   ·  Flag as inappropriate

    On the off-chance that a customer may not want to enable WARM failover without a prompt, perhaps a check for this could be integrated into the installer to provide such a prompt.

Feedback and Knowledge Base

Posted ideas will have one of the following statuses.
Full definition of these statuses can be found on the Home Page.
No status
NEEDS MORE DISCUSSION
RESEARCHING/EVALUATING
DECLINED
PLANNED
STARTED/IN DEVELOPMENT
IN BETA
COMPLETED